Teradek Cube Reference Guide Uživatelský manuál Strana 7

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 40
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 6
Version 2 Dec „11 © Teradek, LLC 2011. All rights reserved.
Page | 7
3. Description of Button and Standard LED Operation
1. LED functions
1.1. USB/PWR (model dependent):
1.1.1. PWR Green is on
1.1.2. USB USB modem status. Off, nothing connected. Green, USB modem connected.
Orange, USB modem connection in progress. Red, USB modem connection failed
1.2. WiFi
1.2.1. Cube 100/200 USB modem status (see above).
1.2.2. Cube 120/150, 220/250, 320/350, 420/450 Wireless status. Off, wireless disabled.
Red, wireless disconnected. Green, wireless associated/connected.
1.3. ENC/DEC Green, encoding/decoding. Orange, no video detected. Red, codec is restarting
or recording is in progress.
1.4. VID Off, no video sync. Green, video sync. Orange, resolution mismatch. Red, resolution
not supported.
2. Button operation Hold down the reset/‟Go Live‟ button for the indicated times to use the
following functions:
2.1. 1-3 seconds (Livestream/RTSP Announce/RTMP mode only): Broadcast start or stop. ENC
LED blinks green rapidly, and then indicates broadcast status. See Stream Modes (page
15) for more information.
2.2.
1-4 seconds (Other stream modes), 7-9 seconds (Livestream, etc.): Pairing ENC/DEC and
WiFi LEDs blink green rapidly. See the Decoder section, page 14 for more information.
2.3. 10-15 seconds: Network reset WiFi LED cycles red, amber, green. Cube resets all network
settings to their defaults and reboots.
2.4. 20+ seconds: Full factory reset ENC and WiFi LEDs cycle red, amber, green. Cube
configuration is restored to factory defaults and the unit reboots.
2.5. NOTE: when your stream type is set to „Live Internet Streaming‟ or „RTSP Announce,‟ the
button operation changes as follows:
2.5.1. 1-3 seconds: Broadcast start or stop. ENC LED blinks green rapidly, and then indicates
broadcast status. See Stream Modes (page 15) for more information.
2.5.2. 7-9 seconds: Pairing see above.
Zobrazit stránku 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 39 40

Komentáře k této Příručce

Žádné komentáře